DEVELOPMENT PROTOTYPE BOARD WITH USB, 4x CAN, RS232, ETHERNETFEATURES:

MCU: LPC2294 16/32 bit ARM7TDMI-S™t with 256K Bytes Program Flash, 16K Bytes RAM, EXTERNAL MEMORY BUS, RTC,4x 10 bit ADC 2.44 uS, 2x UARTs, 4x CAN, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operation
standard JTAG connector with ARM 2x10 pin layout for programming/debugging with ARM-JTAG
1MB (256Kx32bit) 12 ns 71V416 SRAM
4MB (512Kx16bit) 70ns TE28F320C3BD70 C3 INTEL FLASH
USB to RS232 convertor, board can take power only from USB port
4 CAN drivers and connectors
RESET circuit with exterman control of Philips ISP utility via USB-RS232 virtual port
Jumpers for boot select from external memory
Jumpers for ISP/RUN mode
Ethernet controller with CS8900A and RJ45 connector
LCD 16x2 DISPLAY with BACKLIGHT
2 BUTTONS
POTENTIOMETER connected to AIN0
SPI connector
RS232 driver and connector
DALLAS i-BUTTON interface and connector
I2C 24LC515 EEPROM on board
two on board voltage regulators 1.8V and 3.3V with up to 800mA current