MCU: LPC2294 16/32 bit ARM7TDMI-S™t with 256K Bytes Program Flash, 16K Bytes RAM, EXTERNAL MEMORY BUS, RTC,4x 10 bit ADC 2.44 uS, 2x UARTs, 4x CAN, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operation
1MB (256Kx32bit) 12 ns 71V416 SRAM
4MB (2048Kx16bit) 70ns TE28F320C3BD70 C3 INTEL FLASH
standard JTAG connector with ARM 2x10 pin layout for programming/debugging with ARM-JTAG
USB to RS232 convertor, board can take power only from USB port
two on board voltage regulators 1.8V and 3.3V with up to 800mA current
optional single power supply: +5VDC required if not connected to USB port
power supply and status LED
power supply filtering capacitor
Slide switch for ICSP-RUN mode
Slide switch for Boot mode from external internal flash
RESET circuit with exterman control of Philips ISP utility via USB-RS232 virtual port
RESET button
DBG jumper for JTAG enable
BSL jumper for bootloader enable
JRST jumper for enable/disable external RESET vontrol by RS232
removable crystal on socket (default 14.7456 Mhz crystal installed)
extension headers for all uC ports with IDC34 connectors (easy obtainable as used for HDD and Floppy on all PCs)
PCB: FR-4, 1.5 mm (0,062"), green soldermask, white silkscreen component print